RBanta66
Well-known member
Recently purchased a CVA Cascade XT in 7PRC. Topped it with a Athlon ARES BTR GEN2 4x27x50 WITH THE APLR 4 reticle, in a set of Warne MTN Tech rings. Adjusted the trigger down to 2.3lbs. ADG brass, RL26, Berger 175 EH some CCI 250s. So far looks like it's gonna shoot pretty darn well. Took it out to the range a month ago and was not disappointed. I loaded up 66.5, thru 68gns of RL 26 in half grain increments 3 shot groups, 68 gn shot a .390. So with only 23 rounds down the barrel I loaded up 27 more rounds at 68gns same seating depth except I did load 3 .005 (.015 off lands) closer and 3 .005 (.025 off lands) further then my initial test depth. We'll it didn't like. 015 at all but .025 was almost as good as the original at .550. I also ran 3 thru the chronograph and was very pleased, #1 2973mv, #2 2963mv, #3 2978mv for a SD of 5.4 and ES of 10. After that I took it over to the 1k range and hit steel on the 600, 800, 900, and 1k targets. The 1k target looked close to a half moa 5 shot group. Might have been a tad over half but impact was right at the waterline center mass on target. For a inexpensive budget rifle so far it's shooting beyond its price point. Here's a couple pics. On a side note, just had to buy a Cascade rifle since I grew up hunting the Cascade mountains in my home state of Oregon.











