dennisinaz
Active member
- Joined
- Dec 3, 2021
- Messages
- 258
- Reaction score
- 184
- Points
- 43
Any of you guys built one of these yet?





I debated between the two but I’ve always wanted a x47 in the line up so went 25. Might still add one at some pointI am having Bartlein do a 25GT barrel for me which is very similar to the 25x47, just a bit less case capacity. The great thing about those cartridges is very little powder, not overbored, very little recoil, can spot your shots, and they have plenty of velocity with the big 25s. Great target cartridges.
I went with a SAC sizer and a Wilson inline seater cut by my gunsmith. You could use any 6.5x47 dies and just change out bushing.What do you do for dies? Any suggestions for a company that does prefits in 25x47 or a known good reamer i can order?
Since I built my 25CM before anything was available, this is what I do with a set of Redding Elite 6.5 CM bushing dies and a SAC Black Nitride bushing.I went with a SAC sizer and a Wilson inline seater cut by my gunsmith. You could use any 6.5x47 dies and just change out bushing.
Sorry, "s prefit" ? "s tighter neck"?Because I could only find Apha reamers and they're carbide i just went with s prefit
Same chamber many PRC rifles made with.
PT&G has one with s tighter neck but it will still be a no-turn neck.
I loaded up some Lapua brass and measured it. Should have .006" total clearance with the standard neck
Don't understand your question
Possibly a typo, s was supposed be aIn your post you wrote "s prefit", what is "s prefit"? Likewise you wrote "s tighter neck" what does that mean? I don't understand what "s" is.
I'm running an Alpha w/ .150" freebore. It seemed like a good fit to me. I can jam or jump with it and still have enough bullet in case. Had a .180" before, maybe a bit more. Had to jump at least .055" to have a decent hold on 135hyb.I have now decided to go the 25x47 route. Thinking that if I were to do an NRL event it would have a tough time making power factor with the 25GT. 25x47 has just enough more case capacity to get up to 2,850 with the Berger 135 to safely make the 380,000.
What freebore are you all going with?
PTG and Manson both say their reamers are cut for the 133 & 135 Bergers to seat at the neck/shoulder junction. The reamers are a .132 and .135 freebore respectively. The Alpha Munitions reamer comes in .150, .180 or .220 freebore lengths. The Alpha reamer also has a chamber that is .006 tighter than the PTG or Manson reamers. This essentially locks you into their brass. Finally 4D Rentals has PTG reamers on order.

